Isys iTerra Elite II Color LED Plotter Bedienungsanleitung

iTerra Elite-ll Auto-Stacker Installation Guide

June 2011: Revision 001 10 STEP 7 Remove all the blue packing tape from the Auto-Stacker.

June 2011: Revision 001 11 STEP 8 Attach the Auto-Stacker to the feeder and use the screws with external star washers to attach the stacker t

June 2011: Revision 001 12 STEP 9 Place a ruler on top right end of the Auto-Stacker’s funnel as shown above. 1-13/16” (46mm)

June 2011: Revision 001 13 STEP 10 On the support bracket loosen the adjustment setscrew lock nut. Using a 1/8” allen key turn the height

June 2011: Revision 001 14 STEP 11 Attach the power supply to the Auto-Stacker. The Auto-Stacker is now ready to use.

June 2011: Revision 001 2 Table of Contents 1. Limitation of Liability ...

June 2011: Revision 001 3 1. Limitation of Liability The Imaging Systems Group’s total liability to the purchaser, or to any third party,

June 2011: Revision 001 4 2. Unpacking the Box STEP 1 The Auto-Stacker box will come with the following items.  Brackets and screws 

June 2011: Revision 001 5 STEP 2 Ensure that two people lift the Auto-Stacker out of the box.

June 2011: Revision 001 6 3. Assembling the Auto-Stacker STEP 3 Included in the box are  1 set of brackets  4 6-32 x ½ PP type screws and

June 2011: Revision 001 7 STEP 4 Using the screws with flat washers, attach the brackets to the back of the feeder chassis.

June 2011: Revision 001 8 STEP 5 Remove the printer’s back door by pushing the door left to release the door pin.

June 2011: Revision 001 9 STEP 6 The printer on top of the feeder with the door removed, ready to have the Auto-Stacker attached.